Google+ Followers

Sunday, October 10, 2010

drug sub


I was asked a question as to how I fixed the top to the hull. Around the joint area there was 2" by 1/4" flat bar shaped to fit the fiberglass boat and was bolted into position and the cabin was welded to this. In the photo the flat bar is shown. Under the fiberglass large washers 2"x2" were placed to spread the load. Silicon sealant was used to seal the joint. The cabin was tack welded to this flat bar and the whole lot was taken off to fully weld. There was little scorching of the glass surface.

No comments:

Post a Comment